Draytek

Purpose

This guide shows how to configure a Draytek Vigor device for SpotOn.

Prerequisites

You will require the Vigor 2862, 3220, 2926, 2952 Series with 3.9.0 firmware or above in order to continue.

You will require a RADIUS password and a Custom URL from the SpotOn Support team. Chat with us, send an e-mail ([email protected]) or give us a call (050 211 5201).

Network Setup

Log in to your Draytek web interface and go to Hotspot Web Portal. Select Profile Setup on the left menu.

Click an available Index, i.e. 1 and configure the following parameters:

Enable this Profile: Yes 
Portal Method: External Portal Server 
Captive Portal URL: https://portal.spotonwifi.com/auth/vendor/[CUSTOM ID]/draytek 
Redirection URL: http://portal.spotonwifi.com 

Note: SpotOn support can provide you your CUSTOM ID.

Under “RADIUS Server” select the following MAC address format:

aa-bb-cc-dd-ee-ff

Click “External RADIUS Server” and set the following parameters:

Enable: Yes 
Server IP Address: 94.124.94.160 
Destination Port: 1812 
Shared Secret: Ask the SpotOn team for the RADIUS password 
Confirm Shared Secret: Ask the SpotOn team for the RADIUS password 
Enable Accounting: Yes 
Accounting Port: 1813

A router reboot will be required at this point. When the router is accessible after reboot continue to the next step.

In Hotspot Web Portal > Profile Setup click Save and Next to go to “Whitelist Setting” page. Select the “Dest Domain” tab. Add and enable the entries listed here, one per index.

Press Save and Next to continue. Then configure the following attributes:

HTTPS Redirection: Enable 
Captive Portal 
Detection: Enable 
Landing Page After Authentication: User Requested URL 
Applied Interfaces: <Select SSID(s) you wish to enable the service on>

Press Finish to save.